Notifications
Clear all
DavidShower said:
JillSnider said:
Incorrect Parameter has another SPR: # 56411
Ok, partially the same error message - different circumstances.
I asked about your SPR and GE sent back that it occurs in CPS 11 (maybe 12 too?). Occurred when putting a document on hold with clinical list changes signed. Error is Error occurred in class , method CMLRouteDocumentDlg::OnSign The parameter is incorrect. "WORKAROUND: There is no workaround to SIGN the document but you can uncheck clinical list changes and then put on hold and it wiill go on hold without crashing. You will have to wait at least 24 hours til the user will be able to sign. Checked ALL locks- no masterlock - no hard locks."
I don't know if this applies to your situation or not. but we had similar issues where providers were unable to sign an office visit. GEs official answer was wait 24 hours and try again. the work around we found, and it worked every time for us, was to sign off on any new / refill RX before signing the document and the issue went away.
It could at least be something to check for to see if it helps.
Posted : October 7, 2014 12:07 am
I apologize if this is a redundant question, but I am curious if there was a solution to the previous question re: "When creating letters or in the chart text, the bold, italicized and underline buttons are not working?" We are experiencing the same issue since upgrading to CPS 12.
TIA,
Alicia
Posted : February 10, 2015 8:28 am
We are getting ready to upgrade EMR 9.5 to 9.8 - let the games begin!
What type of stress/load testing have any of you used to check for performance issues?
Appreciate any feedback, thanks!
Posted : March 11, 2015 4:01 am
Page 3 / 3
Prev
