Notifications
Clear all
Topic starter
Is anyone currently using this or a similar printer? If so can you share your crystal report or at least share your set up/modification of your existing report.
What we need is a crystal report for printing prescriptions that fits on the
paper here http://www.rxpaper.com/rs-IN.html .
The current crystal report is for 8 1/2 x 11 paper and these are 5.5 x 4.25
which is exactly the size of the current printed prescriptions, but they are 4
to a page so it won't work with these. There would also need to be a different
layout than the current print job since these are pre-printed.
Thanks,
Dawn Duschel LPN
UAP EMR
Posted : November 7, 2013 4:00 am
We are running into a similar issue in that we want to print narcotics to a locked printer but route all other meds to the standard crystal report prescription.
I was under the impression that the crystal reports for prescriptions were based on the state standards and need approval.
I am waiting for a response from GE. I will share what I find out.
Kim
Posted : December 4, 2013 1:48 am
Topic starter
Thanks for the reply. Any help would be greatly appreciated. You are correct about the content on the Rx print out, but ours prints 4 to a page, and that isn't a requirement in our state, but is more efficient than one rx per page. Now with eRx we actually print very few Rx but certainly don't want them all to route to the thermal paper.
Posted : December 7, 2013 3:13 am
Kim,
Did you ever figure this out?
Thanks,
Jeremy
Posted : December 17, 2015 7:26 am
Did you ever get this figured out?
Thanks,
Jeremy
Posted : December 17, 2015 8:38 am
